A mountaineer without legs, but with awesome prosthetics, may have an advantage over a mountaineer whose own legs can experience pain in certain situations. The prosthetics may provide more stability and endurance, and the mountaineer may not experience the same level of pain or fatigue as someone with natural legs. However, the mountaineer with natural legs may have a better sense of balance and proprioception, which could be advantageous in certain climbing scenarios. Ultimately, the advantage would depend on the specific challenges and terrain of the mountain being climbed. **

Yes, a good mountaineer does need toes and fingers. These body parts are crucial for gripping and balancing on the uneven and often treacherous terrain of mountains. Additionally, fingers are essential for using climbing equipment and ropes, while toes provide stability and support during ascents and descents. Without these extremities, a mountaineer would face significant challenges and limitations in their ability to navigate and conquer mountainous landscapes. **

A mountaineer can pee on a cold mountain by finding a sheltered spot away from the wind and snow, and then quickly removing their outer layers of clothing to access their lower layers. They can then squat or stand and aim away from themselves to avoid getting their clothes wet. It's important to work quickly to minimize exposure to the cold and to avoid any potential frostbite. Additionally, some mountaineers may use a portable urination device to make the process easier in extreme conditions. **

One can consider themselves a mountaineer when they start ascending peaks that are at least 14,000 feet (4,267 meters) above sea level. At this altitude, the challenges and risks associated with mountaineering, such as altitude sickness, extreme weather conditions, and technical climbing skills, become more significant. Additionally, the need for specialized gear and training also increases at this altitude, marking the transition from hiking to mountaineering. **

Reinhold Messner was the first mountaineer to climb all 14 eight-thousanders. He completed this incredible feat in 1986 when he summited Lhotse, the fourth highest mountain in the world. Messner is widely regarded as one of the greatest mountaineers of all time and his achievement of climbing all 14 eight-thousanders without supplemental oxygen is considered a remarkable accomplishment in the mountaineering world. **

Yes, the development of innovative car technology was hindered in East Germany due to the country's centralized and state-controlled economy. The government's focus on producing standardized vehicles for the masses limited the ability of car manufacturers to invest in research and development for innovative technology. Additionally, the lack of competition and access to international markets further restricted the advancement of car technology in East Germany. It was only after the reunification of Germany in 1990 that the automotive industry in the former East Germany began to modernize and catch up with Western standards. **

The angle at the cutting edge is the angle formed between the cutting edge of a tool and the workpiece being cut. This angle is crucial in determining the efficiency and effectiveness of the cutting process. A smaller angle at the cutting edge results in a sharper tool, allowing for more precise cuts, while a larger angle may provide more strength and durability to the cutting edge. The optimal angle at the cutting edge depends on the material being cut and the specific cutting operation being performed. **

Possible solutions for skilled workers in metal technology in machining technology include continuous training and upskilling to stay updated with the latest technologies and techniques in the industry. They can also seek certifications or advanced degrees to enhance their knowledge and expertise. Networking with industry professionals and joining professional organizations can provide opportunities for career growth and development. Additionally, considering specialization in a specific area of machining technology can help skilled workers stand out in the field. **